No Products in the Cart
These series of 100% Kolinsky brushes are pre-pinched for precise cuticle application. These are useful for starters but also very practical for the professionals. They are available in sizes The Petite # 6, The Grand # 8, The Master # 10. Have you been looking for a good quality brush for a while? Then you don't have to look any further! Our brushes are made from 100% Kolinsky Sable hairs that last for a long time if you take good care of them, they can last up to 5 years. Our brushes vary in size which is practical for the most novice nail stylists but also for the advanced nail stylists. For starting nail technicians, we recommend The petite 6 or The Grand 8. The higher sizes depend on preference and experience. With an Acrylic Sculptor 16 brush you can encapsulate in one go with a one-ball method, that is not possible with an Acrylic Sculptor 6 brush, you run the risk of the nail breaking off if you do so.
All brushes during the manufacturing process have a "gum" product put into the hairs to aid with shaping and also to protect the hairs till it’s used. This gum product has to be fully removed before using the brush for the first time, if you do not remove this gum from your brushes it can cause discoloration of the product you’re applying and cause the hairs on the brush to split down the middle.
How to prepare brushes before the first use?
Step 1: Firstly, take the protective plastic sleeve off your new brush (never replace the plastic sleeve on to any brush that you’ve used with monomer as the monomer can melt the plastic and damage your brush). With your thumb and forefinger gently start to tease the hairs of your brush and you will see a fine "dust" coming out of the brush. This is the "gum" residue being removed, you must keep doing this until there is no "dust" remaining. For larger brushes it can take quite a few minutes to get all the residue out of it, especially the acrylic brush as it has a large belly on it. Once you are sure all the residue has been removed you can then continue with the advice below for individual preparation depending on what product/system you are going to use with your brush.
Step 2: Once you have prepared your new brush you will now need to "soak" it in monomer. Put a small amount of monomer into a dappendish and dip your brush in and out of it until the brush has soaked up some monomer make sure all air bubbles are removed. Many nail techs put their brush in the dappendish and leave it in there, we advise you not to do this as it can kink the hairs on the brush and cause damage. Whenever you're not using your brush ensure you put it away in a brush case, this will help prevent potential damage and any contamination from things like dust and oils. Never store your acrylic brushes upright either, have the hairs of the brush pointing down or lay your brushes flat, this will help prevent any remaining old monomer from sitting in the belly of your brush and causing contamination. Always check your brush when you've finished your application to ensure no acrylic product is left in it, place your brush into your monomer and gently wipe and re-shape it on paper towel before putting it away. If for any reason you do get any product stuck in your brush, it will of set hard so you will need to use a brush cleaner type product to be able to remove it. Most brush cleaners do have an acetone type product in them and this can dry the hairs of your brush, so we recommend that you only use these types of cleaners if absolutely necessary.
To ensure a prolonged life and optimal performance, proper care and maintenance must be observed:
|Color:||Blue, Purple, White|